Installation Check-Out - Cabletron Systems EMME User Manual

4.2

INSTALLATION CHECK-OUT

After the EMME is connected to the network, verify that packets can be
passed over the network segments via the EMME. Again you can use two
workstations set up as file server and client. Keep the server workstation
stationary in the wiring closet with the EMME, and use the client
workstation to move to each node connected to the EMME (Figure 4-2).
1. After the EMME is installed in the MMAC, connect the server
workstation to either a MIM or to the EMME via an AUI port, using a
transceiver and an AUI cable.
2. Sequentially connect a client workstation to each node connected to
the MMAC and proceed to test the segment.
If a failure occurs, refer to Chapter 7, Troubleshooting.
Figure 4-2. Installation Check-Out Test Configuration
EMME USER'S GUIDE
Office Locations
Client Workstation
INSTALLATION CHECK-OUT
MMAC3/FNB with EMME and TPRMIM
TPT
File Server Workstation
MMAC-3FNB
051444
Page 4-3