Cabletron Systems EMME User Manual page 49

CHAPTER 3: INSTALLING THE EMME
MMAC-M8FNB
Do not reset the EMME during this time.
NOTE
4. After the system boot procedure, the LEDs should be in the following
conditions:
• BOK LED flashing, indicating that the EMME is operating properly.
• STBY (A, B, C, D) LEDs on or off, depending on the port's status after
the Spanning Tree Algorithm has run (Operational-STBY LED OFF or
Blocking-STBY LED ON).
• PWR LEDs lit for the AUI ports, indicating that those ports are
receiving power.
• ON LED lit for the AUI port through which traffic will be passing to,
and from, channel D.
Page 3-6
Board Slot 2
Figure 3-2. Installing the EMME
Repeater MIM
EMME USER'S GUIDE
Knurled
Knobb
051441