Bridging; Trunk Port Security; B.6 Bridging; B.7 Trunk Port Security - Cabletron Systems EMME User Manual

Appendix B: EMME OIDs

B.6 BRIDGING

The following OID is used to enable and disable the interface for the
bridging function.
dot1dstpPortEnable
Description:
Object Identifier:
Data Type:
Values:
Access Policy:

B.7 TRUNK PORT SECURITY

The following OID is required if security is not desired on a trunk port.
The user must force the port to be a trunk port before locking the port via
the module or channel. Failing to do this will cause the port to become
locked out when the third address is seen on the trunk port.
rptrPortSrcAddrForceTrunk
Description:
Object Identifier:
Data Type:
Values:
Access Policy:
Page B-8
The enabled/disabled status of the port.
1.3.6.1.2.1.17.2.15.1.4
Integer
1 = enable
2 = disable
read-write
When this object is set to Force, it places the
port into a Trunk topology state whether or not
the network traffic warrants such a state. When
this object is set to NoForce, it allows the port
to assume the topological state it would
naturally assume based on the network activity
across it. When read, this object reports the
current setting.
1.3.6.1.4.1.52.4.1.1.1.4.3.5.1.4
Integer
1 = NoForce
2 = Force
read-write
EMME USER'S GUIDE