Setting The Default Gateway - Cabletron Systems EMME User Manual

CHAPTER 5: LOCAL MANAGEMENT
3. Press ENTER. If the subnet mask entered was a valid format, the
cursor returns to the beginning of the Subnet Mask field. If the entry
was not valid, the Event Message Line displays "PERMISSIBLE
RANGE: 1...4." Local Management does not alter the current value
and refreshes the Default Interface field with the previous value.
4. Use the arrow keys to highlight the SAVE command.
5. Press ENTER. The Event Message Line at the top of the screen
displays "SAVED OK.".

5.8.7 Setting the Default Gateway

If the SNMP management station is located on a different IP subnet than
the managed device, a default gateway must be specified. When an SNMP
Trap is generated, the device will send it to both the Management station
and the default gateway. To set the default gateway, perform the following
steps:
1. Use the arrow keys to highlight the Default Gateway field.
2. Enter the IP address of the default gateway. IP address entries must
follow the DDN format.
For example: 134.141.79.121
3. Press ENTER. If the default gateway entered was a valid format, the
cursor returns to the beginning of the Default Gateway field. If the
entry was not valid, the Event Message Line displays "INVALID
DEFAULT GATEWAY OR FORMAT ENTERED." Local
Management does not alter the current value and refreshes the Default
Gateway field with the previous value.
4. Use the arrow keys to highlight the SAVE command.
5. Press ENTER. The Event Message Line at the top of the screen
displays "SAVED OK."
Page 5-18 EMME USER'S GUIDE