Cabletron Systems EMME User Manual page 73

CHAPTER 5: LOCAL MANAGEMENT
2. Press SPACEBAR or BACKSPACE to cycle through the available
settings until the operation you require appears. Table 5-3 lists the
available settings and their corresponding applications.
Setting
[LM]
[UPS]
[SLIP]
[UNASSIGNED]
3. Press ENTER to accept the application.
If the SLIP application is chosen for the port, an additional field will
appear to the right of the port field. This is the Baud Rate field. The Baud
Rate field allows the port operating SLIP to be set to the correct baud rate
for its modem connection.
To alter and set the SLIP baud rate, perform the following steps:
1. Use the arrow keys to highlight the COM X Baud Rate field.
2. Press SPACEBAR or BACKSPACE cycle through the available baud
rates for SLIP operation.
The Console port and Modem port support standard baud
NOTE
rates between 300 and 19,200.
3. Press ENTER to select the desired baud rate.
4. Use the arrow keys to highlight the SAVE command.
5. Press ENTER. The Event Message Line at the top of the screen
displays "SAVED OK."
Page 5-20
Table 5-3. COM Port Application Settings
Local Management Session
APC Power Supply SNMP Proxy
Serial Line Internet Protocol
Not Active
Application
EMME USER'S GUIDE