Connecting The Emme To The Network - Cabletron Systems EMME User Manual

3.4

CONNECTING THE EMME TO THE NETWORK

This section provides procedures for connecting the EMME to the
network via the AUI 1 or AUI 2 port. When the EMME is first powered
up, the AUI 1 port acts as the bridge port and the AUI 2 port is off. To
connect to the network via an AUI port:
1. Attach an external transceiver to the segment to which the AUI
connector will be attached.
2. Attach the female end of an AUI cable, no more than 50 meters in
length,
Make sure to disable the SQE test function on the
!
transceiver that you will be connecting to the EMME's AUI
port. Failure to do so will result in improper operation of the
CAU TION
EMME. Refer to the applicable transceiver manual.
3. Attach the male connector on the AUI cable (Figure 3-3) to the
appropriate AUI port on the EMME.
4. Move the slide latch on the AUI port to secure it to the lock posts on
the connector.
EMME USER'S GUIDE
CONNECTING THE EMME TO THE NETWORK
Figure 3-3. Connecting to the AUI Port
051442
Page 3-7