Sample Network Configurations - Cabletron Systems EMME User Manual

To support the additional functionality of the LANVIEW
products, the EPIMs used in products that support LANVIEW
must be at or above the revision levels listed in Table 2-1. The EPIM
revision level is located on the EPIM module and consists of two numbers
following the dash (-) at the end of the part number (e.g., 9031111-xx).
EPIM-3PS
EPIM-A
EPIM-C
EPIM-F1
EPIM-F2
EPIM-F3
EPIM-T
EPIM-X
2.4

SAMPLE NETWORK CONFIGURATIONS

This section provides you with several examples for configuring networks
with the EMME. These following network configuration examples
illustrate the flexibility and advantages to using the EMME and RIC MIM
technology:
• Three networks within a single MMAC-FNB
• A network with a multi-port router
• Adding users to an existing network
• Seven individual networks with a single MMAC-FNB
• A fault tolerant wiring scheme
EMME USER'S GUIDE
SAMPLE NETWORK CONFIGURATIONS
Table 2-1. EPIM Board Revisions
EPIM
EPIM BOARD
REVISION
Not Applicable
Not Applicable
05 or greater
05 or greater
05 or greater
02 or greater
04 or greater
02 or greater
SECURE
SECURE
Page 2-5