Selecting An Update-Freq; Selecting A Network/Slot/Port - Cabletron Systems EMME User Manual

NETWORK - This command lets you select the network you want to
monitor. The choices range from A to D, depending on the configuration
of your network and the options available from this configuration. For
example, if you do not have a device running on Channel A, the EMME
automatically disallows Channel A as a network selection.
SLOT - This command lets you select the MMAC hub slot that you want
to monitor. The choices vary depending on the MMAC chassis you use.
The far right slot is always slot number one (1).
PORT - This command lets you select and view port statistics for ports 1
through 26 of the device residing in the selected slot.

5.13.2 Selecting an Update-Freq

The EMME updates the Device Statistics Screen every three seconds by
default. The EMME allows you to adjust the frequency in intervals of 3
seconds. The maximum update frequency is 99 seconds.
To adjust the Update-Freq, perform the following steps:
1. Use the arrow keys to highlight the Update-Freq command.
2. Press SHIFT+[+], or [–] until the desired time/frequency appears (this
number increments/decrements in 3 second intervals with a minimum
of 3 seconds and a maximum of 99 seconds).
3. Press ENTER to set the Update-Freq.

5.13.3 Selecting a Network/Slot/Port

When the Device Statistics Screen first appears, statistics are displayed
for Network 1, Slot 1 and Port 1. To view statistics for another Network,
Slot, and Port, use the NETWORK x, SLOT x, or PORT x commands at
the bottom of the screen.
To select a Network, Slot, or Port, perform the following steps:
1. Use the arrow keys to highlight the Network, Slot, or Port command.
2. Press SHIFT+[+], or [–] until the desired Network, Slot, or Port
appears.
3. Press ENTER. Statistics associated with the selected Network, Slot, or
Port appear.
EMME USER'S GUIDE
THE DEVICE STATISTICS SCREEN
Page 5-29