Table of Contents
Advertisement
Only qualified personnel should install the SWPIM-T1.
This chapter covers the following items:
•
Unpacking the SWPIM-T1
•
Installing the SWPIM-T1 into the host platform
•
A description of the LANVIEW LED indications
•
Connecting the SWPIM-T1 to the network
•
What to do once the SWPIM-T1 is installed
1.1
UNPACKING THE SWPIM-T1
Use static electricity precautions when handling the SWPIM-T1.
1.
Open the packing box and remove the SWPIM-T1.
2.
Attach the antistatic strap (refer to the instructions in the antistatic
wrist strap package) before removing the SWPIM-T1 from the
antistatic packaging.
Failure to observe static safety precautions could cause
!
damage to the SWPIM-T1. Follow static safety handling rules
CAUTION
and wear the antistatic wrist strap shipped with the SWPIM-T1.
Do not cut the non-conductive bag to remove the device.
Damage could result from sharp objects contacting the device
or components.
3.
Verify that the SWPIM-T1 is undamaged. Refer to
there is any damage to the device. Do not attempt to install the
SWPIM-T1 if it is damaged.
SWPIM-T1 Installation Guide
CHAPTER 1
INSTALLATION
(Section
1.1)
(Section
(Section
(Section
(Section
Getting Help
1.2)
1.3)
1.4)
1.5)
if
1-1
Advertisement
Table of Contents
