Setting Snmp Trap Destinations - Cabletron Systems EMME User Manual

CHAPTER 5: LOCAL MANAGEMENT

5.10.2 Setting SNMP Trap Destinations

To set SNMP Trap destinations using Local Management requires three
distinct operations: the configuration of a destination address for the traps
to be sent to, the assignment of a community name for that IP address,
and the enabling of the combination of IP address and community name.
To set an SNMP trap destination, perform the following steps:
1. Use the arrow keys to highlight the Trap Destination input field you
wish to modify.
2. Type the IP address of the management station to which you want
SNMP traps to be sent. This address must be entered in DDN format.
3. Press ENTER.
4. Use the arrow keys to highlight the corresponding Trap Community
Name input field (on the same row as the Trap Destination field).
5. Type the community name into the input field that you intend the
management station to use for accessing SNMP traps and performing
management operations.
6. Press ENTER.
7. Use the arrow keys to highlight the Enable Traps field (on the same
row as the Trap Destination and Trap Community Name you have just
configured). By default, this toggle item will be [NO].
8. Press SPACEBAR or BACKSPACE to set the toggle field to [YES].
9. Use the arrow keys to highlight the SAVE command.
10. Press ENTER. The Event Message Line at the top of the screen
displays "SAVED OK."
Page 5-24 EMME USER'S GUIDE