Setting Snmp Community Names - Cabletron Systems EMME User Manual

CHAPTER 5: LOCAL MANAGEMENT

5.9.1 Setting SNMP Community Names

To set a community name, perform the following steps:
1. Use the arrow keys to highlight the community name you want to
change.
2. Type the new community name and press ENTER. The old
community name text will disappear and be replaced by the new
community name.
3. Use the arrow keys to highlight the SAVE command.
4. Press ENTER. The Event Message Line at the top of the screen
displays "SAVED OK."
If you edit the super-user community name, be certain you
do not forget it. If you do, you will be unable to perform Local
WARNING
Management functions without returning the device to its
factory default configurations. This will effectively erase any
configuration work you may have done.
Page 5-22 EMME USER'S GUIDE