Setting Pptp Parameters - Enterasys Aurorean ANG-3000 Installation & Service Manual
Virtual network aurorean policy server and aurorean network gateway
Hide thumbs
Also See for Aurorean ANG-3000:
- Application note (64 pages) ,
- Release notes (18 pages) ,
- Installation & service manual (168 pages)
Table of Contents
Advertisement
Chapter 3
Installing Software & Setting Networking Configurables
Setting PPTP Parameters
To set the PPTP parameters of the ANG, perform the following steps:
Aurorean Installation & Service Guide
1
Click on the Protocols option.
The IPsec Configuration window appears as shown in Figure 57.
2
Click on the PPTP tab.
The PPTP configuration window appears as shown in Figure 58.
Figure 58 ANG PPTP Configuration Window
3
Choose to Enable or Disable 128-bit Encryption.
This option can enable 128-bit key Microsoft Point-to-Point
Encryption (MPPE) on the tunnel. To support 128-bit keys, the ANG
may require a 128-bit encryption upgrade available from Microsoft.
NOTE
If 128-bit encryption is chosen, ANGs with 40-bit encryption will not be
able to connect over PPTP with Aurorean Virtual Network.
Configuring the Remote ANG-3000/7000
81
Advertisement
Table of Contents
