Attach The Chassis Sections To The System; Attach Front Brackets To The Rail Assemblies - Enterasys Aurorean ANG-3000 Installation & Service Manual

Chapter 2
Mounting & Connecting Systems

Attach the Chassis Sections to the System

To attach the system to the rail chassis sections, perform the following steps:

Attach Front Brackets to the Rail Assemblies

To connect the front brackets to the rail assemblies, perform the following
steps:
Aurorean Installation & Service Guide
1 Align the holes in the chassis section with the holes in the system as
shown in Figure 10. Do not use the front hole on the system.
2 Fasten the chassis section to the side of the system with four 10/24 x
0.25" panhead Phillips screws.
Figure 10 Attaching Chassis Sections to the System
1 Slide the rack section so the screw holes show through the
rectangular opening in the slider section, as shown in Figure 11.
2 Place the front bracket against the rack section.
3 Line up the slot in the bracket with the holes in the rack section.
Mounting the ANG/APS-3000/7000
Chassis section
Panhead screw
17