Using The Aps-3000/7000 Checklist - Enterasys Aurorean ANG-3000 Installation & Service Manual

Installing APS-3000/7000 Software

Using the APS-3000/7000 Checklist

Use the following checklist to verify you have completed the indicated steps:
36
10 To verify when the APS reboot completes, open a DOS window to the
APS and type ping -t x.x.x.x where x.x.x.x is the APS IP address.
Wait for the "Reply from x.x.x.x" message to display.
All Enterasys services are started, the APS reboots and the VNC
remote control session ends.
CAUTION
If you are migrating the Management.db from one APS to another, or
revising tunnel information stored in the Management.db, you must
reboot the ANG following the change because the ANG now transmits
information to the APS. Failure to reboot the ANG will cause a client kit
build to fail.
! Did you connect your remote control PC to the APS via the hub or
crossover cable?
! Did you bring up a Web browser and enter the location
http://192.168.1.3:5800 (or install the VNC client from the Aurorean
System Software CD ROM and launch the VNC viewer)?
! Did you run Aurorean_3.x.xx-xx\PolicyServer\
setup.exe from the CD?
! Did you select Yes, when asked if you wanted to change your
configuration?
! Did you enter the information exactly as it appears on your VPN
Configuration Worksheet? If you did not have a worksheet, did you
enter the solicited information correctly?
! Did you reboot the APS?
Installing Software & Setting Networking Configurables
Aurorean Installation & Service Guide
Chapter 3