Setting Ospf Properties - Enterasys Aurorean ANG-3000 Installation & Service Manual

Configuring the Remote ANG-3000/7000

Setting OSPF Properties

If your trusted network uses OSPF and you want the ANG to learn and
broadcast OSPF routes, perform the following steps:
66
properties. The values displayed are default parameters.
– Status: the RIP state after changes are applied
– Version: RIP v1 or v2
– Route Import: learn or not learn routes
– Route Export: broadcast or not broadcast routes
– Authentication: simple algorithm or none
2 If used, type the RIP Password and then confirm the entry in the fields
provided.
3 Click Apply Changes.
1 Click the OSPF tab in the Routing Configuration Window.
The OSPF Configuration window appears as shown in Figure 45.
Figure 45 ANG OSPF Routing Configuration Window
2 Set the OSPF configuration state to Enabled or Disabled after
changes are applied.
Installing Software & Setting Networking Configurables
Aurorean Installation & Service Guide
Chapter 3