Install New Ang System Software; Verify Ang's Date And Time; Change The Time Zone; Change The Date And Time - Enterasys Aurorean ANG-3000 Installation & Service Manual

Installing New System Software on the ANG-3000/7000

Install New ANG System Software

On the ANG command line, type: rpm -i --force rts-xxx.i386.rpm where xxx is
the correct release, build and patch number (matching the file you transferred
from the CD ROM) and press

Verify ANG's Date and Time

On the ANG command line, type: date and press
will show the date, time and time zone. For example:
Thu Dec 28 14:36:37 CST 2001

Change the Time Zone

Change the Date and Time

40
NOTE
Ignore the error messages: "user build does not exist"
CAUTION
If you are simply updating the RPM file, first remove the old file by typing
rpm -e --allmatches rts and press
NOTE
The time zone must be set before setting date and time.
1 At the command line type: timeconfig.
2 Use the tab key to select the time zone pulldown box. Use the Up-
Down arrow keys to select the correct time zone.
3 Use the tab key to select OK to choose the new time zone or press
the tab key again to select Cancel; then press
1 On the ANG command line type date then enter MMDDhhmmYY
Installing Software & Setting Networking Configurables
.
ENTER
. Then install as directed above.
ENTER
. The command line
ENTER
.
RETURN
Aurorean Installation & Service Guide
Chapter 3