Resetting A System; Aps/Ang-3000/7000 Series - Enterasys Aurorean ANG-3000 Installation & Service Manual

Resetting a System

Resetting a System

APS/ANG-3000/7000 Series

When you press the Reset button on any APS or ANG (except the ANG-1100),
the system performs a full reset which clears memory, reloads the operating
system, and starts Enterasys services. Figure 64 shows the location of the reset
button on the front panel.
In general, you need to manually reset an APS/ANG-3000/7000 series only
under the following conditions:
The NMI (Non Maskable Interrupt) switch, shown in Figure 64, is recessed
and requires a pen or paper clip to press the button. When depressed, this
switch will cause an NMI to be issued to the system. It is used to dump the
system state when the system is hung. We recommend that you do not use the
NMI switch.
96
Power
Figure 64 APS/ANG-3000/7000 Series Reset Button Location
! After changing one of the system's IP addresses.
! After one of the systems has automatically rebooted (under the
direction of the Overlord service) and you want to resynchronize the
Delivery service.
Sleep Reset NMI
Aurorean Installation & Service Guide
Chapter 4
Basic System Operation