Configuring Name Server Parameters - Enterasys Aurorean ANG-3000 Installation & Service Manual
Virtual network aurorean policy server and aurorean network gateway
Hide thumbs
Also See for Aurorean ANG-3000:
- Application note (64 pages) ,
- Release notes (18 pages) ,
- Installation & service manual (168 pages)
Table of Contents
Advertisement
Chapter 3
Installing Software & Setting Networking Configurables
Configuring Name Server Parameters
Name Server settings are optional. If you do not use DNS or WINS servers on
your network, skip to "Configuring Authentication Parameters" on page 74.
To set the Name Server parameters of the ANG, perform the following steps:
Aurorean Installation & Service Guide
4
Click Add Subnet.
1
Click on the Name Servers option.
The Name Servers Configuration window appears as shown in
Figure 52.
Figure 52 ANG Name Servers Configuration Window
2
Enter an IP address for the Primary and Secondary DNS servers in
the fields provided.
3
Enter an IP address for the Primary and Secondary WINS servers in
the fields provided.
4
Click Apply Changes.
Configuring the Remote ANG-3000/7000
73
Advertisement
Table of Contents
