Installing The Indus River Certificate; Using Internet Explorer (5.X Or Greater Versions Only) - Enterasys Aurorean ANG-3000 Installation & Service Manual

Chapter 3
Installing Software & Setting Networking Configurables

Installing the Indus River Certificate

Installing the Indus River Certificate provides server administration access to
the ANG-3000/7000. The procedure to install the Indus River Certificate
differs depending on the browser you are using, Internet Explorer (IE) 5 or
higher or Netscape Communicator 4 or higher. Both browsers let you use the
certificate either for the duration of the session with the ANG or for all
subsequent sessions until the certificate expiration date.
If you are using Internet Explorer, begin installing the certificate below. Skip
to page 49 if you are using the Netscape browser.

Using Internet Explorer (5.x or greater versions only)

To install the Indus River Certificate using Internet Explorer, perform the
following steps:
Aurorean Installation & Service Guide
1 Be sure your remote control computer's IP address is still set to an
address in the 192.168.1.x range with a subnet mask of
255.255.255.0. Do not use the 192.168.1.2 IP address.
To change the computer's IP address, use the Network Control Panel
and follow Microsoft's on-line Help instructions. To communicate
with the ANG, this computer must have an address in the same
subnet as the Network Gateway.
Configuring General Values of the ANG-3000/7000
43