Configuring The Remote Ang-3000/7000; Setting Routing Parameters; Setting Rip Properties - Enterasys Aurorean ANG-3000 Installation & Service Manual

Chapter 3
Installing Software & Setting Networking Configurables

Configuring the Remote ANG-3000/7000

Since you have already configured General values for the ANG, you are ready
to complete configuration of the Network Gateway.

Setting Routing Parameters

To set routing parameters of the remote ANG, perform the following steps:

Setting RIP Properties

If your trusted network uses RIP and you want the ANG to learn and
broadcast RIP routes, perform the following steps:
Aurorean Installation & Service Guide
1 Click on the Routing option.
The Routing Configuration window appears with the RIP tab
selected by default as shown in Figure 44. If you do not want to
configure RIP as your routing protocol, skip to "Setting OSPF
Properties" on page 66, otherwise continue with Step 2.
Figure 44 ANG RIP Routing Configuration Window
1 Choose the appropriate radio button to select the following RIP
Configuring the Remote ANG-3000/7000
65