Installing Aps-3000/7000 Software - Enterasys Aurorean ANG-3000 Installation & Service Manual

Installing APS-3000/7000 Software

Installing APS-3000/7000 Software
Although the APS ships with most of its operating software already
factory-installed, you must install some additional software from the
Aurorean System Software CD ROM. During this installation, a
Configuration Wizard program is launched that captures networking values
for the APS, such as IP addresses for the Ethernet interfaces.
To access the Policy Server desktop, you will remotely control the Policy
Server using the VNC remote control application. Figure 23 illustrates the
process of installing system software on the APS by connecting it and the
remote control PC with a hub or the provided crossover cable.
Aurorean Policy Server
To connect your remote control PC to the APS, perform the following steps:
32
System
Software
Aurorean System
Software CD ROM
Figure 23 Installing Aurorean Policy Server Software
1 Remove the CD ROM from your remote control PC and insert it in the
CD ROM drive of the APS.
2 Be sure your remote control computer's IP address is set to an
address in the 192.168.1.x range with a subnet mask of
255.255.255.0. Do not use the 192.168.1.1, 192.168.1.2, or
192.168.1.3 IP addresses.
Installing Software & Setting Networking Configurables
Connection
Remotely Control
with no hub
Policy Server Desktop
Use crossover
cable
Hub
Policy Server
Desktop
VNC Session
PC Desktop
Aurorean Installation & Service Guide
Chapter 3