Setting User Parameters - Enterasys Aurorean ANG-3000 Installation & Service Manual

Configuring the Remote ANG-3000/7000

Setting User Parameters

Users on remote ANGs can be either the name chosen for a corresponding
site-to-site ANG or administrators who require access to the Aurorean Web
Config tool. To set User parameters on the ANG, perform the following steps:
The default user netadmin is included by default for ANG and RiverMaster
access. It is included in the default IRAdmin group.
76
1 Click on the Authentication main menu option.
The Users configuration window appears as shown in Figure 55.
NOTE
Figure 55 ANG Users Authentication Configuration Window
2 Click Add User.
The Add User configuration window appears as shown in Figure 56.
Installing Software & Setting Networking Configurables
Aurorean Installation & Service Guide
Chapter 3