Using Netscape (4.X Or Higher Versions Only) - Enterasys Aurorean ANG-3000 Installation & Service Manual

Chapter 3
Installing Software & Setting Networking Configurables

Using Netscape (4.x or higher versions only)

To install the Indus River Certificate, perform the following steps:
Aurorean Installation & Service Guide
windows, respectively. The ANG Log On window appears as
shown in Figure 41.
• Skip to "Logging On the ANG" on page 57 to continue ANG
configuration.
The Indus River Certificate is now either accepted for your current
Aurorean Virtual Network session or installed permanently for all
sessions. Your IE browser will display a closed lock in the lower right
corner of the browser indicating the certificate is in force.
1 Be sure your remote control computer's IP address is still set to an
address in the 192.168.1.x range with a subnet mask of
255.255.255.0. Do not use the 192.168.1.2 IP address.
To change the computer's IP address, use the Network Control Panel
and follow Microsoft's on-line Help instructions. To communicate
with the ANG, this computer must have an address in the same
subnet as the server.
2 Point your Netscape Web browser at the trusted IP address of the
ANG by typing the 192.168.1.2 IP address in the Location field, as
shown in Figure 41.
The first Netscape New Site Certificate window appears as shown in
Figure 34.
Configuring General Values of the ANG-3000/7000
49