Install The Assembled Rails Into The Rack - Enterasys Aurorean ANG-3000 Installation & Service Manual
Virtual network aurorean policy server and aurorean network gateway
Hide thumbs
Also See for Aurorean ANG-3000:
- Application note (64 pages) ,
- Release notes (18 pages) ,
- Installation & service manual (168 pages)
Table of Contents
Advertisement
Mounting the ANG/APS-3000/7000
Install the Assembled Rails into the Rack
To install the assembled rails in the rack, perform the following steps:
20
4
Place the rail assembly against the rack again by hooking the front
bracket over the front of the rack.
5
Slide the rear bracket back until it hooks over the rear of the rack.
6
Hold the rail assembly in place and tighten the screws. Make sure the
fit of the rail assembly to the rack is snug.
Rear bracket
Rack section
Figure 13 Attaching the Rear Bracket to the Rail Assembly
1
Fasten the front bracket to the rack using the screws provided with
the rack as shown in Figure 14.
Lock
washer
Slider section
Aurorean Installation & Service Guide
Mounting & Connecting Systems
Nut
Flat
washer
Chapter 2
Advertisement
Table of Contents
