Ang Linux Kernel Upgrade (3000/7000); Ang Software Upgrade (3000/7000 Only); Verifying The Ang Configuration - Enterasys Aurorean ANG-3000 Installation & Service Manual

Appendix D
Aurorean System Upgrades

ANG Linux Kernel Upgrade (3000/7000)

Follow the instructions in "Install the New Linux Kernel" on page 120.

ANG Software Upgrade (3000/7000 only)

Verifying the ANG Configuration

Perform the following steps to use Admintool, a script to verify the ANG
configuration is correct:
Aurorean Installation & Service Guide
10 Type put Linux-2.2.16-2.i386.rpm and press
11 Type put rts-3.5.xx-xxx.i386.rpm and press
12 When the file transfer is complete, type bye and press
NOTE
This step is required only if the ANG is running Version 3.1.0 or lower.
1 Open a Telnet window on the APS or your laptop and Telnet to the
trusted interface of the ANG.
2 Log in as netadmin, with the password netadmin.
3 Type su - and press
press
.
ENTER
4 Type cd /home/ftp/pub and press
5 Remove the pre-installed ANG software before installing 3.5. Type
rpm -e - -allmatches rts and press
6 Install the new ANG software. Type rpm -i --force rts-3.5.xx-
xxx.i386.rpm and press
Ignore several warning messages which appear during installation.
7 When the Linux prompt (#) returns, type reboot and press
1 When the ANG has rebooted and is available on the network, open a
Type the root password welcome and
.
ENTER
ENTER
ENTER
.
ENTER
Upgrading Release 3.x to 3.5
.
ENTER
.
ENTER
ENTER
or cd ~ftp and press
.
ENTER
.
.
ENTER
.
125