Transfer The New Ang Installation File To The Ang - Enterasys Aurorean ANG-3000 Installation & Service Manual

Chapter 3
Installing Software & Setting Networking Configurables

Transfer the New ANG Installation File to the ANG

Aurorean Installation & Service Guide
1 Be sure the Aurorean System Software CD ROM is inserted in your
remote control computer's CD ROM drive.
2 On your remote control computer, temporarily change the computer's
IP address to an address in the 192.168.1.x range with a subnet
mask of 255.255.255.0. Do not use 192.168.1.1, 192.168.1.2, or
192.168.1.3 IP addresses.
To change the computer's IP address, use the Network Control Panel
and follow Microsoft's on-line Help instructions. To communicate
with the ANG, this computer must have an address on the same
subnet as the ANG.
3 Open a DOS command window.
4 Change directory to: Aurorean_3.x.xx-xx\NetworkGateway
on the CD ROM and press
5 Open an FTP session to the ANG by typing FTP 192.168.1.2 and
press .
ENTER
6 Login as anonymous using your email address as the password or
just press
ENTER
7 Change to binary mode by typing bin and press
8 Transfer the rpm file by typing put rts-xxx.i386rpm where xxx is the
correct release, build and patch number and press
For example, the file may read: rts-3.0.00-95.i386.rpm
9 After the transfer is complete, type bye and press
10 Telnet to the ANG by typing: telnet 192.168.1.2 and press
11 Login by typing netadmin with the password netadmin.
12 At the prompt, type su - for user name, and welcome for the
password to log in with root privileges.
13 Change directory by typing: /home/ftp/pub
14 Issue a list command to verify that the file was transferred to the ANG
by typing ls -ltr and pressing
Installing New System Software on the ANG-3000/7000
.
ENTER
.
ENTER
ENTER
ENTER
ENTER
.
.
.
to exit FTP.
.
ENTER
39