Determine Correct Position For The Rear Brackets - Enterasys Aurorean ANG-3000 Installation & Service Manual

Mounting the ANG/APS-3000/7000

Determine Correct Position for the Rear Brackets

The exact position of the rear bracket in relation to the rail assembly is
determined by the depth of the rack. Because the rack section of the rail
assembly is a fixed length, use the rear bracket placement to set the rail
assembly length so it fits the rack. Figure 12 shows how placement of the rear
bracket will accommodate the depth of any rack.
18
4 Fasten the front bracket to the rack section with two 8/32 x 0.38"
flathead countersunk Phillips screws, washers, lock-washers and
nuts. Attach the washers and nuts in the order shown in Figure 11.
Nut
Lock
washer
Flat
washer
Figure 11 Attaching the Front Bracket
Front bracket
Slider section
Mounting & Connecting Systems
Rack section
on the back side
Rectangular cutout
Aurorean Installation & Service Guide
Chapter 2