Assigning A Community Name - Cabletron Systems SmartSTACK ETHERNET ELS10-27 User Manual

Configuring Your SmartSTACK Ethernet ELS10-27
Port 16 has been assigned to a segment that includes ports that belong to
workgroup A and workgroup B. Port 13 connects workgroup A to the
router and port 24 connects workgroup B to the router.
All packets remain within the workgroup.
Use the LCM command, workgroup, to create, modify, and delete virtual
workgroups. The full syntax of the command is as follows:
workgroup [NAME [{delete | PORT-RANGE}]]
To display all of the workgroups deÞned by the SmartSTACK Ethernet
ELS10-27, at the LCM prompt:
Type
workgroup
To display information about a speciÞc workgroup, at the LCM prompt:
Type
workgroup NAME
To create or modify a workgroup, at the LCM prompt:
Type
workgroup NAME PORT-RANGE
To delete a workgroup, at the LCM prompt:
Type
workgroup NAME delete
To create or modify the port list for a speciÞc workgroup, at the LCM
prompt:
Type
workgroup NAME PORT-RANGE
To display the network classiÞcation of a speciÞc workgroup, at the LCM
prompt:
Type
workgroup NAME

3.12 ASSIGNING A COMMUNITY NAME

A community name is similar to a password. You use the same steps to
assign a new community name or to change an existing community
name. You can then enter a community name to perform any SNMP sets.
The default password is public the Þrst time you access the device.
To assign a community name, at the LCM prompt:
1. Type
community
2. Enter the old community name.
3-16