Cabletron Systems SmartSTACK ETHERNET ELS10-27 User Manual page 73

Unpacking and Installing Your SmartSTACK Ethernet ELS10-27
4. Verify that a Link exists by checking that the port LINK LED is solid
green. If the LINK LED is off, perform the following steps until it is
on:
a. Check that the power is turned on for the device at the other end
of the Link.
b. Verify proper crossing over of fiber strands between the
applicable port on the SmartSTACK Ethernet ELS10-27 and the
fiber optic device at the other end of the fiber optic link segment.
c. Verify that the fiber connection meets the dB loss specifications.
If a Link has not been established, contact Cabletron Systems. Refer to
Section 1.2, Getting Help, for details.
The SmartSTACK Ethernet ELS10-27 is now ready to be set up through
Local Management. Refer to Chapter 4, Monitoring and Managing Your
SmartSTACK Ethernet ELS10-27, to conÞgure the SmartSTACK Ethernet
ELS10-27.
10BASE-T/100BASE-TX
25X 26X 27X
Figure 2-7. EPIM100-FX Port
EPIM100
LNK
EPIM-100FX
LNK
EPIM-100FX
EPIM100
2-13