Lcm Command Summary - Cabletron Systems SmartSTACK ETHERNET ELS10-27 User Manual

Introduction
help or ?
addresses display [any] [ADDR [MASK]]
arp display
baud [BAUD-RATE]
bridge [PORT-RANGE [OPTIONS]
community
disable [? for syntax]
enable [? for syntax]
erase
exit or logout
ident
igmp [on | off]
ipaddr [IPADDR [MASK]]
ipmÞlter [? for syntax]
ipmrouter {add | delete} PORT-RANGE
kill {session-number}
mirror [? for syntax]
ping [-rvsx] HOST [DATASIZE [COUNT]] send ICMP ECHO_REQUEST pkts
port [? for syntax]
query [on |off] [name]
reboot [? for syntax]
route [? for syntax]
session
switch [? for syntax]
status[PORT-RANGE/clear PORT-RANGE] to display unit or port status
sttimer [TIMER-VALUE]
traceroute [? for syntax]
trapcontrol [on | off]
traplog
trunk [? for syntax]
vlan [? for syntax]
workgroup [? for syntax]
1-20

LCM Command Summary

to display learned addresses
to display the ARP table
to change the console baud rate
to set bridging methods
to change the password/community
to disable a set of ports
to enable a set of ports
to erase conÞguration
to logout
to display unit identiÞcation
to enable IPM Þltering by snooping IGMP
to set or display IP addresses
to statically Þlter out ports
to set or display IP Multicast Router ports
to kill a session (console use only)
to set or display port mirroring
to set or display port parameters
to act as an IGMP Querier
to reboot the unit after SECONDS
to display routing table information
to display current LCM sessions
to set or display switch parameters
to set or display st age time
to print the route taken to a host
to set or display traps control value
to display the most recent SNMP traps
to set display trunking status
to conÞgure IEEE Vlans
to set or display workgroups
Display this menu