Using The Reset Switch - Cabletron Systems ESXMIM Installation Manual

Ethernet switch module

Hide thumbs Also See for ESXMIM:

Table of Contents

4.3

USING THE RESET SWITCH

The ESXMIM incorporates a recessed reset switch, located above the

LEDs (See Chapter 2, Controls and Indicators, for location). This reset

switch initializes the ESXMIM processor. This switch does not initialize

Non-Volatile Random Access Memory (NVRAM), the non-volatile

random access memory where the ESXMIM stores network management

parameters.

To use the reset switch, use a pen or pencil to press the switch in. When

this is done, the ESXMIM initializes itself.

The reset sequence for the ESXMIM may last approximately

NOTE

one minute. The ﬁnal time may change depending upon the

conﬁguration of the chassis in which the ESXMIM is located.

Only after the reset sequence is completed will bridging or

switching resume.

ESXMIM/ESXMIM-F2 Installation Guide

Using The Reset Switch

4-5

Table of Contents

Do you have a question about the ESXMIM and is the answer not in the manual?

Esxmim-f2