Cabletron Systems ESXMIM Installation Manual page 52

Chapter 4: Troubleshooting
Condition
Cannot contact
the ESXMIM from
in-band
management
User Parameters
(IP address,
Device and
Module Name,
etc.) are lost
when device is
powered down
4-4
Possible Cause
Improperly
configured
Community
Names table
ESXMIM does
not have an IP
address
No link to device
Switch 7 has
been toggled
and
user-entered
parameters
have been reset
to factory default
NVRAM may be
defective
ESXMIM/ESXMIM-F2 Installation Guide
Recommended Action
Refer to ESXMIM/ESXMIM-F2
Local Management Guide for
Community Names table setup.
Refer to ESXMIM/ESXMIM-F2
Local Management Guide for IP
address Setup Screen information.
Check link to device for validity and
proper functioning of all
intermediary devices.
Reset one or more parameters and
cycle power to module. If
parameter altered has remained in
memory, re-configure remaining
parameters. Do not change the
position of switch 7 to attempt to
rectify this situation. See Chapter
3, Installation, for details.
If NVRAM is defective, call
Cabletron Systems Technical
Support.