Cabletron Systems ESXMIM Installation Manual page 17

Parts of the ESXMIM
EPIM Slot
The EPIM slot is a covered opening in the ESXMIM faceplate that can be
configured with an optional EPIM module. For a list of EPIM modules
which may be used in the ESXMIM, refer to Appendix B, BRIM/EPIM
Information.
Reset Button
The recessed reset button re-initializes the ESXMIM processor. The
activation of this switch will not initialize Non-Volatile Random Access
Memory (NVRAM) where the ESXMIM stores configuration and
management parameters. The Reset button may be pressed with the point
of a pencil or pen. Once pushed in, the ESXMIM will re-initialize itself.
LANVIEW LEDs
The ESXMIM incorporates the LANVIEW status monitoring and
diagnostic system. LANVIEW LEDs can help diagnose many problems,
such as a fault in network cabling. LANVIEW LEDs are identified in
Section 2.1.3, LANVIEW LEDs.
RJ45 Ports
The ESXMIM module provides five front panel RJ45 ports for connection
to 10BASE-T links. The RJ45 ports of the ESXMIM use the 10BASE-T
standard pinouts and signaling.
ST Ports
The ESXMIM-F2 provides five pairs of front panel ST ports for
connection to five 10BASE-F links. The ST ports of the ESXMIM-F2 are
10BASE-F and FOIRL compliant.
Serial Ports
The ESXMIM faceplate provides two serial communications ports for the
connection of out-of-band management devices.
ESXMIM/ESXMIM-F2 Installation Guide 2-3