Advertisement
Correct use
TIP
Hydraulic and pneumatic lines are marked with
coloured protective covers, which identify the appro-
priate system line.
(5) - figure (4.6) For of the hydraulic
parking stand, after lifting, set the
selective control valve lever in the
tractor to the "neutral" position.
• Turn off tractor engine and remove
key from ignition. Close the tractor
cab to ensure that unauthorised
persons do not have access to the
tractor cab. Immobilise the tractor
with parking brake.
• The trailer hitched to the tractor must
be level. Empty trailer may be slightly
tilted forward from the level (about
50 mm). If the trailer is not level,
adjust the position of the hitch on the
tractor or the position of the trailer
drawbar - section (4.1).
• Connect
the
system lines (applies to a 2-line pneu-
matic system).
• Connect hydraulic brake system line
(applies to hydraulic brake system).
The connection socket is different
than in other systems (female socket).
• Connect hydraulic tipping system
line.
• Connect lines of the tailgate hydraulic
pneumatic
braking
1
2
3
4
Figure 4.6
Trailer connections
(1) pneumatic brake plug, (2) electric wire, (3)
hydraulic line, (4) hydraulic brake socket
system. Connect the line to the
same section of the tractor hydraulic
IMPORTANT
When connecting pneumatic lines of a 2-line system,
first connect the pneumatic line marked yellow, and
then the line marked red.
manifold.
• Connect the hydraulic system lines
of the lower walls. Connect the line
to the same section of the tractor hy-
draulic manifold.
PRONAR T700M/1
Section 4
624-H.02-1
4.11
Advertisement
