Advertisement
FIRST USE OF THE TRAILER
ATTENTION
During the first use, the trailer is checked in the pres-
ence of the Seller. The Seller is obliged to conduct
the training in safe and correct operation of the trailer.
Training by the seller does not release the user from
the obligation to read this manual and follow the in-
structions in it.
Before you start using the machine, you
should familiarize yourself with its design,
principle of operation, available equipment
and operation and, above all, with safety
rules.
PROCEDURE
• The user must read this Operator's
Manual and observe all the recom-
mendations contained in it.
• Perform the daily inspection of the
machine in accordance with the
guidelines in the inspection schedule.
• Check all the machine lubrication
points, lubricate if necessary ac-
cording to the recommendations in
the lubrication schedule.
• Check correct tightening of bolt and
nut connections (in particular connec-
tions of suspension system, drawbar
eye and wheels).
• Ensure that pneumatic, hydraulic and
electrical connections in agricultural
tractor are according to the require-
ments, if not the trailer should not be
6
PRONAR T700M/1
hitched to the tractor.
• Make sure that the oil of the same
kind and grade is used in the trailer
hydraulic system and the tractor hy-
draulic system.
• Adjust the height of the drawbar eye
to the tractor hitch
If all the above checks have been per-
formed and there is no doubt as to the
trailer good technical condition, it can be
connected to tractor.
Start the tractor, check all systems and
conduct test run without load (no load
in load box). It is recommended that the
inspection is conducted by two people,
one of which should always remain in the
tractor cab. Test start should be conducted
according to the sequence shown below.
• Connect the machine to the appro-
priate hitch on the agricultural tractor.
• Connect the braking, electrical and
hydraulic systems.
• Raise support to transport position.
• Turn on individual lights, check the
operation of the electrical system.
• Activate and check the operation
of the following hydraulic systems:
tailgate, side walls, raising and low-
ering the load box, hydraulic parking
stand
(if
present),
Introduction
axle
turning
Advertisement
