PRONAR T700M/1 Translation Of The Original Copy Of The Manual page 148

Section 6
IMPORTANT
Clamp jaws must be placed at the load bearing cable
side figure (6.2).
Protect the cable ends using a heat shrink tubing.
The distance between the clamps should be 15 mm.
The first clamp must be located as close as possible
to the thimble.
6.4 PRONAR T700M/1
other end of the cable in the same
way.
• Adjust tension of the cable - section
(5.15.)
• Tighten the nuts.
• Tighten the crank mechanism cable
and then loosen it. If necessary,
correct the brake cable tension.
Maintenance
J.3.2.589.02.1.EN