Advertisement
Correct use
4.12
OPERATE CHUTE SLIDE GATE
As standard, the tailgate of the load box
is equipped with a chute slide gate (1) -
figure (4.11) and additionally it can be
equipped with a chute (2) for unloading
bulk materials.
Chute design allows very accurate dosing
of the material to packaging (sacks, boxes
etc.). The opening gap can be controlled
using lever (3). To do this, loosen the bolt
locking the slide gate (4), open the slide
gate at the desired height and secure it
again with the bolt.
During unloading through chute, load
box must be raised slowly and smoothly.
Raising the load box quickly will exert large
pressure on the rear part of the load box
due to displacement of the carried material
DANGER
When closing the chute slide gate, be especially
careful to avoid crushing your fingers.
3
Figure 4.11
Operate the chute
(1) chute slide gate, (2) chute, (3) lever,
(4) locking bolt
and could compromise trailer stability.
PRONAR T700M/1
Section 4
4
2
1
623-H.08-1
H.3.11. 623. 12.1.EN
4.27
Advertisement
