Advertisement
Design and operation
plug (9).
The trailer system consists of two inde-
pendent circuits:
• circuit (A) - to supply the hydraulic
cylinder of the first trailer,
• circuit (B) - to supply the hydraulic
cylinder of the second trailer, if two
trailers are hitched to the tractor.
The three-way valve (2) is used to switch
these circuits on. This valve's lever can be
placed in two positions:
• 1 - trailer tipping circuit opened -
circuit (A),
• 2 - second trailer tipping circuit
opened – circuit (B).
The hydraulic system has a cut-off valve
(3) controlled by a cable (6) limiting the tilt
angle of the load box.
IMPORTANT
The length of the control cable is set by the Manufac-
turer and it must not be adjusted by the User.
PRONAR T700M/1
Section 3
G.3.3.259.05.1.EN
3.13
Advertisement
