Advertisement
Section 4
4.5 OPERATE OF THE HYDRAULIC SHEAR PARKING STAND
5
Figure 4.5
Adjusting the drawbar height
(1) shear type drawbar support, (2) hydraulic cylinder, (3) hydraulic line for lifting the support,
(4) hydraulic line for lowering the support, (5) plug cap (red), (6) line hanger
TIP
To protect the plugs and identify the system, the lines
are secured with red plugs (5).
POSITION THE PARKING STAND IN
• Immobilize the tractor and trailer with
the parking brake.
The trailer must be hitched to the
tractor. Connect the hydraulic
lines (3) and (4) to the tractor
hydraulic sockets.
• While controlling the selective control
valve in the tractor, raise the parking
stand foot by inserting the piston rod
4.8
PRONAR T700M/1
6
3
4
5
DRIVE POSITION
1
IMPORTANT
Do NOT drive off with the parking stand lowered. The
parking stand must be in driving (raised) position.
of the hydraulic cylinder (2).
• Release the parking brake before
driving off.
ADJUST THE PARKING STAND TO
• Immobilise tractor and trailer with
parking brake.
The trailer must be hitched to
the tractor.
• While controlling the selective control
valve in the tractor, lower the parking
Correct use
2
623-H.05-1
PARKING POSITION
Advertisement
