Advertisement
Correct use
• Turn the crank in proper direction in
order to raise the parking stand foot
(2) maximally upwards.
• If the parking support loses contact
with the ground, the parking support
gear can be shifted to a higher gear.
To do this, pull the crank in di-
rection (C).
• Install securing pin.
• Set the crank in neutral position (A).
ADJUST THE PARKING STAND TO
• Remove safety pin.
Raise the parking stand foot
slightly upwards, it will make it
PARKING POSITION
IMPORTANT
Do NOT drive off with the parking stand lowered. The
parking stand must be in driving (raised) position.
easier to remove the securing
pin.
• Set the parking stand foot position
by turning the pin into the correct
position.
• Move crank (3) to position (B) or (C).
• Turn the crank in correct direction in
order to lower the parking stand foot
to the ground or adjust the drawbar
eye height in relation to the hitch (if
the trailer is to be hitched to tractor)
PRONAR T700M/1
Section 4
H.3.11.623.04.1.EN
4.7
Advertisement
