Advertisement
Section 4
4.4 TELESCOPIC SUPPORT OPERATION
Figure 4.4
Adjusting the drawbar height
(1) telescopic parking stand, (2) parking stand foot, (3) crank, (4) gear, (5) securing pin
(A) neutral position, (B) position - 1st gear (speed under load), (C) position - 2nd gear (high speed)
IMPORTANT
Remember that the high gear of the crank gear, posi-
tion (C) of the crank, may be used only for operating
the support if the support foot is not loaded. Use this
gear only when the foot is not resting on the ground.
Proper height of drawbar eye in relation to
tractor hitch can be set using the telescopic
support with mechanical gear (figure 4.4).
Position (C) is used for fast rising and low-
ering the support foot in order to reduce
the distance between the support foot and
the ground. Position (B) is used to lower
and raise the drawbar of the unloaded
4.6
PRONAR T700M/1
1
Be especially careful when operating the support –
this refers also to bystanders or helpers.
machine. In position (B), the support foot
(2) moves slowly and a large force is not
required to raise the machine drawbar.
POSITION THE PARKING STAND IN
• Remove safety pin (5).
• Press the parking stand crank (3)
from neutral position (A) to position
(B).
4
1
2
DANGER
DRIVE POSITION
Correct use
B
C
A
3
5
623-H.04-1
Advertisement
