Pilz PSSu K F FAU B Operating Manual page 39

Function description
ADJUSTMENT state
Users can request ADJUSTMENT state via the web interface (see web interface: Adjust-
ment). In ADJUSTMENT state users can adjust the tool during initial commissioning and
tool change. ADJUSTMENT state can be ended either via the web interface or via an oper-
ating state with higher priority (e.g. requesting STANDBY state via the PSS 4000 user pro-
gram, HALT state, ERROR state, IDLE state due to ending the operating state "Device in
RUN state without error" on the safety controller).
In ADJUSTMENT state, PSENvip will not process the following requests:
}
Switching to MEASUREMENT state (request via the add-on module PSENvip IPM)
} Firmware update (request via the web interface)
The firmware update option is deactivated in the web interface.
Fig.: Request/end ADJUSTMENT state
Operating Manual PSSu K F FAU B, PSSu K F FAU P
1003434-EN-05
RUN
Request ADJUSTMENT
Request ADJUSTMENT
HALT
Web interface: Adjustment
JUSTAGE
End ADJUSTMENT
| 39