Aah See "Fill Data Carrier (S#); Extended Commands For Tag Type Idc - Pepperl+Fuchs IC-KP2-1HB6-2V15B Manual

IC-KP2-1HB6-2V15B
Commands
Fill data carrier (S#)
Command:
Byte Content
Byte 0 Command code (AAh)
Byte 1 Reserved/Ident channel/Toggle bit
Byte 2 Start address
Byte 3 Start address
Byte 4 Word count
Byte 5 Word count
Byte 6 Character
Response:
Byte Content
Byte 0 Command code (AAh)
Byte 1 Reserved/Ident channel/Toggle bit
Byte 2 Status
Byte 3 Reply counter
The word number <WordNum> of fill signs <Fill Sign> is written to the read/write
tag from the specified start address <WordAddr>.
Extended commands for type IDC-... and IUC... tags
Type IDC-...-1K tags can be programmed to read 24-bit information (so-called
special read only code) very quickly. This is useful for detecting containers in
automated warehouses.
Length of the special read only code:
Tag of the type IDC-...-1K:
■
Tag of the type IUC:
■
To write the special read only code use the commands SP and EP; to read it
out, use the commands SS and ES.
If SP or EP is used to write to an IDC-...-1K tag, the tag is then locked. If you wish
to write to the tag again using standard commands, unlock it using the command
SI.
Bit no.
7 6 5 4 3
1 0 1 0 1
<Reserved> <Channel>
<WordAddr> (high byte)
<WordAddr> (low byte)
<WordNum> (high byte)
<WordNum> (low byte)
<Fill sign>
Bit no.
7 6 5 4 3
1 0 1 0 1
<Reserved> <Channel>
<Status>
<ReplyCounter>
48 bit
96 ... 240 bit
2 1 0
0 1 0
<T>
2 1 0
0 1 0
<T>
63