Pepperl+Fuchs IC-KP2-1HB6-2V15B Manual page 24

IC-KP2-1HB6-2V15B
Commissioning
6.4 Address setting
Assign the IDENTControl Compact an address between 0 (00h) and 125 (7Dh)
that is not already assigned to another node. The device address is set in the
hexadecimal system.
You have two options to set the device address:
1. using the rotary switches
2. via the PROFIBUS
Note!
The rotary switches used to select the device address are located on the
underside of the IDENTControl Compact. These rotary switches are no longer
accessible once the IDENTControl Compact is installed.
Note!
If you would like to set the device address via the PROFIBUS, turn the rotary
switch to position "7Eh" ... "FEh" or "FFh". The address "7Eh ... FEh" may only be
used for commissioning purposes.
However, you can only configure the device address via the PROFIBUS if the
device is the only node on the bus with the address 126. Otherwise, set the
address using the rotary switches before connecting the device to the bus.
After switching on, the IDENTControl Compact automatically adopts the transfer
rate specified by the master. Select the maximum cable length permitted for this
transfer rate (see chapter 5.4.6).
Switch setting
Switch setting
00 ... 7D
7E ... FE
FF
Setting the device address via the rotary switch
There are two rotary switches for setting the device address located on the
underside of the device.
1. Select the relevant address ("00h" ... "7Dh") using the rotary switches.
2. Switch the device off and back on again so that the PROFIBUS adopts the
device address.
24
Address
modification
Address after possible via
switching on "Set_Slave_Add"?
0 ... 125 No
126 Yes
Stored address Yes
(default setting:
126)
Address during
operation Meaning
0 ... 125 Normal
(permanent) address
126 or Commissioning
modified address
address
Stored or Start with
modified stored address
address