Boot Prom Mode - Cabletron Systems SmartSwitch Router User's Reference Manual

Chapter 1: SSR Product Overview
pvst
qos
radius
rate-limit
rdisc
rip
rmon
sfs
smarttrunk
snmp
stp
system
tacacs
tacacs-plus
vlan
web-cache
Special configuration mode commands:
clear
diff
erase
negate
no
save
search
show
To exit Configure mode and return to Enable mode, use one of the following commands:
Exit Configure mode.

Boot PROM Mode

If your SSR does not find a valid system image on the external PCMCIA flash, the system
might enter programmable read-only memory (PROM) mode. You should then reboot the
SSR at the boot PROM to restart the system. If the system fails to reboot successfully,
please call Cabletron Systems Technical Support to resolve the problem.
To reboot the SSR from the ROM monitor mode, enter the following command.
Reboot in Boot PROM mode.
38
- Configure Per Vlan Spanning Tree Protocol
(PVST)
- Configure Quality of Service parameters
- Configure RADIUS related parameters
- Configure rate limits for flows
- Configure Router Discovery Protocol
- Configure Routing Information Protocol (RIP)
- Configure RMON related parameters
- Configure SecureFast Switching (SFS) parameters
- Configure SmartTRUNK
- Configure SNMP related parameters.
- Configure STP parameters
- Configure system-wide parameters
- Configure TACACS related parameters
- Configure TACACS+ related parameters
- Configure VLAN-related parameters
- Configure web caching parameters
- Show configuration commands
- Compare active configuration against another
configuration
- Erase configuration information
- Negate a command or a group of commands
using line numbers
- Negate matching commands
- Save configuration information
- Look up a command in configuration
- Show configuration commands
exit
Ctrl+Z
reboot
SmartSwitch Router User Reference Manual