Cabletron Systems SmartSwitch Router User's Reference Manual page 111

Authentication
Update interval
To change RIP parameters, enter the following commands in Configure mode.
Set RIP Version on an interface
to RIP V1.
Set RIP Version on an interface
to RIP V2.
Specify that RIP V2 packets
should be multicast on this
interface.
Specify that RIP V2 packets that
are RIP V1-compatible should
be broadcast on this interface.
Change the metric on incoming
RIP routes.
Change the metric on outgoing
RIP routes.
Set the authentication method
to simple text up to 8
characters.
Set the authentication method
to MD5.
Specify the metric to be used
when advertising routes that
were learned from other
protocols.
Enable automatic summari-
zation and redistribution of RIP
routes.
Specify broadcast of RIP
packets regardless of number of
interfaces present.
Check that reserved fields in
incoming RIP V1 packets are
zero.
SmartSwitch Router User Reference Manual
RIP Parameter
rip set interface
rip set interface
rip set interface
rip set interface
rip set interface
rip set interface
rip set interface
rip set interface
rip set default-metric
rip set auto-summary disable|enable
rip set broadcast-state always|choose|never
rip set check-zero disable|enable
Chapter 8: RIP Configuration Guide
Default Value
None
30 seconds
<interfacename-or-IPaddr>
version 1
<interfacename-or-IPaddr>
version 2
<interfacename-or-IPaddr>
type multicast
<interfacename-or-IPaddr>
type broadcast
<interfacename-or-IPaddr>
<num>
metric-in
<interfacename-or-IPaddr>
<num>
metric-out
<interfacename-or-IPaddr>
authentication-method simple
<interfacename-or-IPaddr>
authentication-method md5
|all
|all
|all
|all
|all
|all
|all
|all
<num>
111