Cabletron Systems SmartSwitch Router User's Reference Manual page 36

Chapter 1: SSR Product Overview
ip
ip-policy
ip-redundancy
ip-router
ipx
l2-tables
lfap
load-balance
logout
mtrace
multicast
nat
ntp
ospf
ping
port
ppp
pvst
qos
radius
rate-limit
rdisc
reboot
rip
rmon
sfs
smarttrunk
snmp
statistics
stp
system
tacacs
tacacs-plus
telnet
traceroute
vlan
web-cache
To exit Enable mode and return to User mode, use one of the following commands:
Exit Enable mode.
36
- Show IP related parameters
- Show IP policy information
- Show IP Redundancy information (VRRP)
- Show unicast IP Routing related parameters
- Show IPX related parameters
- Show L2 Tables information
- Show LFAP parameters
- Show Load Balancing related parameters and
hosts
- Log off the system
- Multicast Traceroute utility
- Configure Multicast related parameters
- Show Network Address Translation related
parameters
- Network Time Protocol (NTP)
- Show/Monitor Open Shortest Path First Protocol
(OSPF).
- Ping utility
- Show or change Port parameters
- Display Point to Point Protocol (PPP)
statistics
- Show Per Vlan Spanning Tree Protocol (PVST)
parameters
- Show Quality of Service parameters
- Show RADIUS related parameters
- Show rate-limit policy information
- Show Router Discovery Protocol (RIP) parameters
- Reboot the system
- Show/Query Routing Information Protocol(RIP)
tables
- Show RMON related parameters
- Show SecureFast Switching (SFS) parameters
- Show SmartTRUNK information
- Show SNMP related parameters.
- Show or clear SSR statistics
- Show STP status
- Show system-wide parameters
- Show TACACS related parameters
- Show TACACS+ related parameters
- Telnet utility
- Traceroute utility
- Show VLAN-related parameters
- Configure web caching parameters
exit
Ctrl+Z
SmartSwitch Router User Reference Manual