Creating An Import Source; Creating A Route Filter; Creating An Aggregate Route - Cabletron Systems SmartSwitch Router User's Reference Manual

Chapter 11: Routing Policy Configuration Guide
To create route import policies, enter the following command in Configure mode:
Create an import policy.
The <imp-src-id> is the identifier of the import-source that determines the source of the
imported routes. If no routes from a particular source are to be imported, then no
additional parameters are required.
The <filter-id>, if specified, is the identifer of the route-filter associated with this import-
policy. If there is more than one route-filter for any import-source, then the ip-router
policy import source <imp-src-id> command should be repeated for each <filter-id>.

Creating an Import Source

Import sources specify the routing protocol from which the routes are imported. The
source may be RIP or OSPF.
To create an import source, enter one of the following commands in Configure mode:
Create a RIP import
destination.
Create an OSPF import
destination.

Creating a Route Filter

Route policies are defined by specifying a set of filters that will match a certain route by
destination or by destination and mask.
To create route filters, enter the following command in Configure mode:
Create a route filter.

Creating an Aggregate Route

Route aggregation is a method of generating a more general route, given the presence of a
specific route. The routing process does not perform any aggregation unless explicitly
requested. Aggregate-routes can be constructed from one or more of the following
building blocks:
180
ip-router policy import source
<filter-id>
[filter
[exact|refines|between
[preference
ip-router policy create rip-import-source
ip-router policy create ospf-import-source
ip-router policy create filter
<IP-address/mask>
SmartSwitch Router User Reference Manual
<imp-src-id>
<ipAddr-mask>
|[network
<low-high>
<number>
|restrict]]]
<name-id>
]
<name>
<name>
network