Configure Mode - Cabletron Systems SmartSwitch Router User's Reference Manual

Configure Mode

Configure mode provides the capabilities to configure all features and functions on the
SSR. You can configure features and functions within Configure mode including router
configuration, access control lists and spanning tree.
To list the Configure commands, enter:
List the Configure commands.
The Configure mode command prompt consists of the SSR name followed by the pound
sign (#):
ssr(config)#
To list the commands available in Configure mode, enter a question mark (?) as shown in
the following example:
ssr(config)# ?
acl
acl-edit
acl-policy
aging
arp
bgp
cli
dhcp
dvmrp
exit
filters
frame-relay
help
igmp
interface
ip
ip-policy
ip-redundancy
ip-router
ipx
lfap
load-balance
nat
ntp
ospf
port
ppp
SmartSwitch Router User Reference Manual
?
- Configure L3 Access Control List
- Edit an ACL in the ACL Editor
- Configure ACL policy
- Configure L2 and L3 Aging
- Configure ARP entries
- Configure Border Gateway Protocol (BGP)
- Modify the command line interface behavior
- Configure DHCP server
- Configure DVMRP related parameters
- Exit current mode
- Configure L2 security filters
- Configure wan interface parameters
- Describe online help facility
- Configure IGMP related parameters
- Configure interface related parameters
- Configure IP related parameters
- Configure IP policy for packet forwarding
- Configure IP redundancy protocols
- Configure Unicast Routing Protocol related
parameters
- Configure IPX related parameters
- Configure Lightweight Flow Accounting Protocol
client
- Configure Load Balancing related parameters
- configure network address translation
parameters
- Configure Network Time Protocol (NTP)
parameters
- Configure Open Shortest Path Protocol (OSPF)
- Configure Port parameters
- Configure wan interface parameters
Chapter 1: SSR Product Overview
37