Enabling And Disabling Rip; Configuring Rip Interfaces; Configuring Rip Parameters - Cabletron Systems SmartSwitch Router User's Reference Manual

Chapter 8: RIP Configuration Guide

Enabling and Disabling RIP

To enable or disable RIP, enter one of the following commands in Configure mode.
Enable RIP.
Disable RIP.

Configuring RIP Interfaces

To configure RIP in the SSR, you must first add interfaces to inform RIP about attached
interfaces.
To add RIP interfaces, enter the following commands in Configure mode.
Add interfaces to the RIP
process.
Add gateways from which
the SSR will accept RIP
updates.
Define the list of routers to
which RIP sends packets
directly, not through
multicast or broadcast.

Configuring RIP Parameters

No further configuration is required, and the system default parameters will be used by
RIP to exchange routing information. These default parameters may be modified to suit
your needs by using the rip set interface command.
Version number
Check-zero for RIP reserved parameters
Whether RIP packets should be broadcast
Preference for RIP routes
Metric for incoming routes
Metric for outgoing routes
110
rip start
rip stop
rip add interface
rip add trusted-gateway
rip add source-gateway
RIP Parameter
<interfacename-or-IPaddr>
<interfacename-or-IPaddr>
<interfacename-or-IPaddr>
Default Value
RIP v1
Enabled
Choose
100
1
0
SmartSwitch Router User Reference Manual